![]() Since you are doing a 4EV range, would it be slightly better to be somewhat conservative and dial in a 1/3EV of reserve here if working quickly? I assumed that Enfuse would work best with minimal processing beforehand, but I will try pulling back exposure first as you suggest. I havn't done any further processing, though I guess that could improve matters more. For instance, if you slide the Exposure slider to 5 on a well-exposed image with no clipped highlights, you're likely to see some highlight clipping warnings, but the highlights in the base file are still not clipped. The LR highlight warning is showing clipping in part of the sky, where none was apparent in either of the darker two exposures.īe aware that just because you see clipping warnings in Lightroom, it doesn't mean that the highlights are actually clipped in the base image. I used to use all 5 exposures from my brackets in all of my Enfused images, but I found that alignment was sometimes tough with 5 images, and I also found that using just the brightest and darkest images from the bracket series often yields results with a tonal range that I find pleasing. I'll sometimes adjust other settings in the files - white balance, NR, etc., prior to running them through enfuse. Since it's only two files I'm feeding into Enfuse, the process doesn't take too long, and that allows me to play around a little and try different processing regimes. Lately I've played with setting whites and highlights to -100, blacks and shadows to +100 and contrast to -100 in both files before feeding them into Enfuse. I raise the shadows and exposure in the darkest file, then lower the highlights and exposure in the brightest file. I usually choose just 2 images - the darkest and brightest, although I'll sometimes opt for something less than the brightest if I feel the brightest is too compromised. This results in a bracket series where the darkest shot is optimally ETTRed. ![]() I then dial in around two additional EVs before firing off the bracket sequence. ![]() I first use the live highlight clipping warnings to determine an optimal ETTR exposure. I always take a high speed 5-shot, 1EV bracket. Here's how I've been doing this recently using my E-M5, with, for me, acceptable results: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |